/* -*- Mode: C++; tab-width: 4; indent-tabs-mode: nil; c-basic-offset: 4 -*- */
/* ***** BEGIN LICENSE BLOCK *****
 * Version: MPL 1.1/GPL 2.0/LGPL 2.1
 *
 * The contents of this file are subject to the Mozilla Public License Version
 * 1.1 (the "License"); you may not use this file except in compliance with
 * the License. You may obtain a copy of the License at
 * http://www.mozilla.org/MPL/
 *
 * Software distributed under the License is distributed on an "AS IS" basis,
 * WITHOUT WARRANTY OF ANY KIND, either express or implied. See the License
 * for the specific language governing rights and limitations under the
 * License.
 *
 * The Original Code is mozilla.org code.
 *
 * The Initial Developer of the Original Code is
 * Netscape Communications Corporation.
 * Portions created by the Initial Developer are Copyright (C) 1998
 * the Initial Developer. All Rights Reserved.
 *
 * Contributor(s):
 *
 * Alternatively, the contents of this file may be used under the terms of
 * either the GNU General Public License Version 2 or later (the "GPL"), or
 * the GNU Lesser General Public License Version 2.1 or later (the "LGPL"),
 * in which case the provisions of the GPL or the LGPL are applicable instead
 * of those above. If you wish to allow use of your version of this file only
 * under the terms of either the GPL or the LGPL, and not to allow others to
 * use your version of this file under the terms of the MPL, indicate your
 * decision by deleting the provisions above and replace them with the notice
 * and other provisions required by the GPL or the LGPL. If you do not delete
 * the provisions above, a recipient may use your version of this file under
 * the terms of any one of the MPL, the GPL or the LGPL.
 *
 * ***** END LICENSE BLOCK ***** */

#include "nsIRequest.idl"

interface nsIURI;
interface nsIInterfaceRequestor;
interface nsIInputStream;
interface nsIStreamListener;

/**
 * The nsIChannel interface allows clients to construct "GET" requests for
 * specific protocols, and manage them in a uniform way.  Once a channel is
 * created (via nsIIOService::newChannel), parameters for that request may
 * be set by using the channel attributes, or by QI'ing to a subclass of
 * nsIChannel for protocol-specific parameters.  Then, the URI can be fetched
 * by calling nsIChannel::open or nsIChannel::asyncOpen.
 *
 * After a request has been completed, the channel is still valid for accessing
 * protocol-specific results.  For example, QI'ing to nsIHttpChannel allows
 * response headers to be retrieved for the corresponding http transaction.
 *
 * This interface must be used only from the XPCOM main thread.
 */
[scriptable, uuid(e0bb5c49-c54e-4efb-8f0d-6a7edd926fab)]
interface nsIChannel : nsIRequest
{
    /**
     * The original URI used to construct the channel. This is used in
     * the case of a redirect or URI "resolution" (e.g. resolving a
     * resource: URI to a file: URI) so that the original pre-redirect
     * URI can still be obtained.  This is never null.  Attempts to
     * set it to null must throw.
     *
     * NOTE: this is distinctly different from the http Referer (referring URI),
     * which is typically the page that contained the original URI (accessible
     * from nsIHttpChannel).
     */
    attribute nsIURI originalURI;

    /**
     * The URI corresponding to the channel.  Its value is immutable.
     */
    readonly attribute nsIURI URI;

    /**
     * The owner, corresponding to the entity that is responsible for this
     * channel.  Used by the security manager to grant or deny privileges to
     * mobile code loaded from this channel.
     *
     * NOTE: this is a strong reference to the owner, so if the owner is also
     * holding a strong reference to the channel, care must be taken to 
     * explicitly drop its reference to the channel.
     */
    attribute nsISupports owner;

    /**
     * The notification callbacks for the channel.  This is set by clients, who
     * wish to provide a means to receive progress, status and protocol-specific 
     * notifications.  If this value is NULL, the channel implementation may use
     * the notification callbacks from its load group.  The channel may also
     * query the notification callbacks from its load group if its notification
     * callbacks do not supply the requested interface.
     * 
     * Interfaces commonly requested include: nsIProgressEventSink, nsIPrompt,
     * and nsIAuthPrompt/nsIAuthPrompt2.
     *
     * When the channel is done, it must not continue holding references to
     * this object.
     *
     * NOTE: A channel implementation should take care when "caching" an
     * interface pointer queried from its notification callbacks.  If the
     * notification callbacks are changed, then a cached interface pointer may
     * become invalid and may therefore need to be re-queried.
     */
    attribute nsIInterfaceRequestor notificationCallbacks;

    /**
     * Transport-level security information (if any) corresponding to the channel.
     */
    readonly attribute nsISupports securityInfo;

    /**
     * The MIME type of the channel's content if available. 
     * 
     * NOTE: the content type can often be wrongly specified (e.g., wrong file
     * extension, wrong MIME type, wrong document type stored on a server, etc.),
     * and the caller most likely wants to verify with the actual data.
     *
     * Setting contentType before the channel has been opened provides a hint
     * to the channel as to what the MIME type is.  The channel may ignore this
     * hint in deciding on the actual MIME type that it will report.
     *
     * Setting contentType after onStartRequest has been fired or after open()
     * is called will override the type determined by the channel.
     *
     * Setting contentType between the time that asyncOpen() is called and the
     * time when onStartRequest is fired has undefined behavior at this time.
     *
     * The value of the contentType attribute is a lowercase string.  A value
     * assigned to this attribute will be parsed and normalized as follows:
     *  1- any parameters (delimited with a ';') will be stripped.
     *  2- if a charset parameter is given, then its value will replace the
     *     the contentCharset attribute of the channel.
     *  3- the stripped contentType will be lowercased.
     * Any implementation of nsIChannel must follow these rules.
     */
    attribute ACString contentType;

    /**
     * The character set of the channel's content if available and if applicable.
     * This attribute only applies to textual data.
     *
     * The value of the contentCharset attribute is a mixedcase string.
     */
    attribute ACString contentCharset;

    /**
     * The length of the data associated with the channel if available.  A value
     * of -1 indicates that the content length is unknown. Note that this
     * is a 64-bit value and obsoletes the "content-length" property used on
     * some channels.
     */
    attribute PRInt64 contentLength;

    /**
     * Synchronously open the channel.
     *
     * @return blocking input stream to the channel's data.
     *
     * NOTE: nsIChannel implementations are not required to implement this
     * method.  Moreover, since this method may block the calling thread, it
     * should not be called on a thread that processes UI events.  Like any
     * other nsIChannel method it must not be called on any thread other
     * than the XPCOM main thread.
     *
     * NOTE: Implementations should throw NS_ERROR_IN_PROGRESS if the channel
     * is reopened.
     */
    nsIInputStream open();

    /**
     * Asynchronously open this channel.  Data is fed to the specified stream
     * listener as it becomes available.  The stream listener's methods are
     * called on the thread that calls asyncOpen and are not called until
     * after asyncOpen returns.  If asyncOpen returns successfully, the
     * channel promises to call at least onStartRequest and onStopRequest.
     *
     * If the nsIRequest object passed to the stream listener's methods is not
     * this channel, an appropriate onChannelRedirect notification needs to be
     * sent to the notification callbacks before onStartRequest is called.
     * Once onStartRequest is called, all following method calls on aListener
     * will get the request that was passed to onStartRequest.
     *
     * If the channel's and loadgroup's notification callbacks do not provide
     * an nsIChannelEventSink when onChannelRedirect would be called, that's
     * equivalent to having called onChannelRedirect.
     *
     * If asyncOpen returns successfully, the channel is responsible for
     * keeping itself alive until it has called onStopRequest on aListener or
     * called onChannelRedirect.
     *
     * Implementations are allowed to synchronously add themselves to the
     * associated load group (if any).
     *
     * NOTE: Implementations should throw NS_ERROR_ALREADY_OPENED if the
     * channel is reopened.
     *
     * @param aListener the nsIStreamListener implementation
     * @param aContext an opaque parameter forwarded to aListener's methods
     * @see nsIChannelEventSink for onChannelRedirect
     */
    void asyncOpen(in nsIStreamListener aListener, in nsISupports aContext);

    /**************************************************************************
     * Channel specific load flags:
     *
     * Bits 23-31 are reserved for future use by this interface or one of its
     * derivatives (e.g., see nsICachingChannel).
     */

    /**
     * Set (e.g., by the docshell) to indicate whether or not the channel
     * corresponds to a document URI.
     */
    const unsigned long LOAD_DOCUMENT_URI = 1 << 16;

    /** 
     * If the end consumer for this load has been retargeted after discovering 
     * its content, this flag will be set:
     */
    const unsigned long LOAD_RETARGETED_DOCUMENT_URI = 1 << 17;

    /**
     * This flag is set to indicate that this channel is replacing another
     * channel.  This means that:
     *
     * 1) the stream listener this channel will be notifying was initially
     *    passed to the asyncOpen method of some other channel
     *
     *   and
     *
     * 2) this channel's URI is a better identifier of the resource being
     *    accessed than this channel's originalURI.
     *
     * This flag can be set, for example, for redirects or for cases when a
     * single channel has multiple parts to it (and thus can follow
     * onStopRequest with another onStartRequest/onStopRequest pair, each pair
     * for a different request).
     */
    const unsigned long LOAD_REPLACE = 1 << 18;

    /**
     * Set (e.g., by the docshell) to indicate whether or not the channel
     * corresponds to an initial document URI load (e.g., link click).
     */
    const unsigned long LOAD_INITIAL_DOCUMENT_URI = 1 << 19;

    /**
     * Set (e.g., by the URILoader) to indicate whether or not the end consumer
     * for this load has been determined.
     */
    const unsigned long LOAD_TARGETED = 1 << 20;

    /**
     * If this flag is set, the channel should call the content sniffers as
     * described in nsNetCID.h about NS_CONTENT_SNIFFER_CATEGORY.
     *
     * Note: Channels may ignore this flag; however, new channel implementations
     * should only do so with good reason.
     */
    const unsigned long LOAD_CALL_CONTENT_SNIFFERS = 1 << 21;

    /**
     * This flag tells the channel to use URI classifier service to check
     * the URI when opening the channel.
     */
    const unsigned long LOAD_CLASSIFY_URI = 1 << 22;
};
